« previous next »
Pages: [1]   Go Down

Author Topic: bodykit  (Read 2318 times)

0 Members and 1 Guest are viewing this topic.

Offline CS2rex

  • antrx.com full member
  • ***
  • Posts: 209
  • Karma: +5/-3
  • Gender: Male
  • formerly mark_sss
bodykit
« on: Mar 5, 2006, 10:52AM »
hey dudes im pretty sure im gettin a kit shipped over canada from IBI-bodykits  ;D and im looking round for fitting, anywhere no of a good, but not to expensive panel beater in bris that works with fibreglass?

or

is fbreglass hard to fit, my dad and i have done heaps of body work to cars before(bogging, painting, Rebuilding front ends, u no, the usual haha) but i have heard fibreglass is hard to work with and dont really no how big a task it would be to take on. if you have any ideas or suggestions plz post! thanks
Logged

Offline Jono

  • The Wise Man
  • Global Moderator
  • post whore
  • ****
  • Posts: 5748
  • Karma: +159/-40
  • Gender: Male
  • memory boy!
Re: bodykit
« Reply #1 on: Mar 5, 2006, 06:13PM »
Have a look around on the net, there's heaps of info about 'glassing out there.

Fibreglassing isn't that hard.
Logged
#1 Post Wh0re
pringles was here!

Offline Barnett

  • antrx.com senior member
  • ****
  • Posts: 495
  • Karma: +11/-21
  • Gender: Male
  • Not So Stock Ride, Banging Your Mum 24/7 :D
Re: bodykit
« Reply #2 on: Mar 5, 2006, 06:50PM »
dude if its a kit for your car it will be a matter of getting it painted and putting it on......

[Barnett]
Logged
Mmmmm Turbo Mini Chopper Anyone?
Pages: [1]   Go Up
« previous next »