Author Topic: Front bar idea?  (Read 2039 times)

0 Members and 1 Guest are viewing this topic.

Offline MattJohn

  • senior member
  • ****
  • Posts: 391
  • Karma: +3/-0
Front bar idea?
« on: Jul 1, 2011, 02:54PM »
I havnt done any research about it yet, but would an 89ish Mitsubishi Galant front bar fit a U12?
Galant front bars can have some nice mods and neat front lips and if they fit it I think it could look pretty fine ???

Somthing Like

Ideas, opions, (facts haha)?
« Last Edit: Jul 1, 2011, 03:07PM by MattJohn »

Offline slitstitch

  • pre-pewbie newbie
  • *
  • Posts: 1
  • Karma: +0/-0
Re: Front bar idea?
« Reply #1 on: May 7, 2012, 07:45AM »
im also thinking about that, anyone have an idea?

Offline Colby

  • post whore
  • *****
  • Posts: 2395
  • Karma: +36/-5
  • Gender: Male
  • KA24DE powered TRX
Re: Front bar idea?
« Reply #2 on: May 7, 2012, 02:56PM »
Your main issue may be width.  If you can find the width of the galant ie. front wheel stance width and compare to U12.  within about 100mm you should be able to make it work without cutting. 
Other issue is the little lip down the side of the quarter panel infront of the front wheel arch/ under the turning light.  U12 doesnt have the lip there so you might find a small gap opens up near the guard flare.  Does look like a pretty good style match though.

Offline pedro666

  • post whore
  • *****
  • Posts: 2351
  • Karma: +26/-8
  • Gender: Male
  • VET NEO VVL is how I roll...
Re: Front bar idea?
« Reply #3 on: Feb 16, 2013, 06:56PM »
i was thinking of swapping an s13 bumper re-enforcements bar then one of many aftermarket?
the words "race car" spelled backward still spell "race car"?