I have searched and wanted to double check before digging up old threads.
My car has the dreaded design flaw where the driver's wiper hits the end of the windscreen (long time ago got stuck there).
The bolt that holds it down is loose as well, needs a new one.
Just wanted to clarify after replacing the retaining bolts (and I read this in another thread) to stop it hitting the end (if it does after tightening the bolt) to get the grab the entire linkage and sort of bend in in the middle so the left part of it is more inverted?
And also, I looked through the FSM and searched for it and it was probably because I had next to no light while searching, cannot find the Consult Port/Diagnostic Data Link. I have my alarm which is duct taped (dodgy installs FTL!!!) which was probably blocking my view and will have to search in better light probably tomorrow but yeah can anyone say exactly which side of the steering wheel it is located under?
I may have missed it in the FSM both Corsair/Pintara but it only showed it for the CA20E engine... is it in the same place?
And last but not least when removing the sun sensor from the grill as I will be changing the dash, the wires that are connected to it pop out/ clip out etc?? Will probably see it when I pull it out but thought I would check as I don't want to rip the wire or whatever...

Cheers guys..
