« previous next »
Pages: [1]   Go Down

Author Topic: painting a spoiler  (Read 7335 times)

0 Members and 1 Guest are viewing this topic.

Offline Pinsair

  • ka24e owner
  • post whore
  • *****
  • Posts: 1046
  • Karma: +14/-4
  • Gender: Male
painting a spoiler
« on: May 20, 2003, 08:37PM »
ok i have a red spoiler on its way in the mail and a beige car, whats teh best way to spray it.  Is it worth trying it at home or should i take it to a paint and panel place? if so how much do u reckon they'd charge me?
Logged

Offline noss

  • Administrator
  • post whore
  • *****
  • Posts: 13882
  • Karma: +278/-50
  • Gender: Male
  • great scott!
    • antrx
Re:painting a spoiler
« Reply #1 on: May 20, 2003, 09:17PM »
do it yourself champ... you'd get charged a fortune at a panel shop

sand it back so the red paint is roughed up, but make sure its still smooth enough so it wont look dodgy when its painted.. paint it with a light coloured primer, like grey (most primers are grey anyway) then beige away.. too easy  ;D
Logged

http://polyfedelicio.us/imgs/ - free image hosting for whatever you like

Offline ZEXTCY

  • antrx.com junkie
  • *****
  • Posts: 825
  • Karma: +24/-3
  • Gender: Male
  • I dare ya
Re:painting a spoiler
« Reply #2 on: May 20, 2003, 11:20PM »
If you do this yourself here`s a general rundown:

If it has any scratches etc in it which i bet it does sand these out with 240 wet and dry, if they are REALLY deep you might need to use 120 dry and then the 240 route to fix the problem.
Spray a very fine mist coat over the spoiler with black paint - This will be a guide for you while sanding the whole spoiler with 240 wet and dry after you have all scratches out etc
P.S. - Always use a block and not your fingers wherever possible

After you have sanded this back spray it over with a couple coats of spray putty and then another mist of black as guide.  Let cure for day or two in sun so it`s had time to shrink etc.
Sand this back with 600 wet and dry paper

Now apply your undercoat - Wait till dry and sand back with 1000 wet and dry
Allow 24 hours at least before sanding again though

Now you can paint the spoiler the same color as your car - Allow around 5 minutes between coats for flashing of paint.  Allow around 20 mins before applying clear if using it

Now let sit in sun for at least 48 hours for best results before rubbing this back with 1800 or 2000 wet and dry.  You only do this though if you intend buffing it (which is recommended if your after a really nice shine)
If you don`t have a buffing machine etc it might pay to take into shop and get them to buff for you as it is very easy to burn paint etc whilst doing this

If you have any questions feel free to ask
Logged
What is the point of a signature, who REALLY reads it??

Offline Pinsair

  • ka24e owner
  • post whore
  • *****
  • Posts: 1046
  • Karma: +14/-4
  • Gender: Male
Re:painting a spoiler
« Reply #3 on: May 21, 2003, 07:14PM »
ok thanks alot for the help, what paint should i get? where from etc?
Logged

Offline ZEXTCY

  • antrx.com junkie
  • *****
  • Posts: 825
  • Karma: +24/-3
  • Gender: Male
  • I dare ya
Re:painting a spoiler
« Reply #4 on: May 21, 2003, 08:57PM »
if you intend doing it yourself get acrylic paint
you`ll also need thinners to mix into it as well

any auto paint store in your area will be able to help you out
Logged
What is the point of a signature, who REALLY reads it??

Offline Pinsair

  • ka24e owner
  • post whore
  • *****
  • Posts: 1046
  • Karma: +14/-4
  • Gender: Male
Re:painting a spoiler
« Reply #5 on: May 21, 2003, 10:32PM »
thanks for the help  ;D
Logged

Offline aussie-gli

  • post whore
  • *****
  • Posts: 1059
  • Karma: +17/-5
  • Gender: Male
  • CA20E GLi (1998 -> 2008) U12 TRX (2020 -> ...)
Re:painting a spoiler
« Reply #6 on: May 22, 2003, 12:08AM »
Here's a few pointers....

* If the paint on the spoiler is in good nick, just rub it back with 800 and spray your colour over that.

* Only apply clear if you're using metalic paint.

* once finished, rub back your new paint with 2000 wet/dry paper, and treat it with a really good polish.

* If you haven't got a good compressor and gun, get it sprayed professionally. Don't bother with cans and shit like that.
Logged
Lisa: Dad, we did something very bad! Homer: Did you wreck the car? Bart: No. Homer: Did you raise the dead? Lisa: Yes. Homer: But the car's okay? Bart & Lisa: Uh-huh. Homer: All right then.

Offline Pinsair

  • ka24e owner
  • post whore
  • *****
  • Posts: 1046
  • Karma: +14/-4
  • Gender: Male
Re:painting a spoiler
« Reply #7 on: May 23, 2003, 01:17AM »
Quote
* If you haven't got a good compressor and gun, get it sprayed professionally. Don't bother with cans and shit like that.

i havent got a compressor and gun but i dont reallt want to get it done professionally as it doesnt have to look that good cos my paint job isnt in the best condition anyway. Thanks for the help tho  ;D

i'll just do it with cans i think. as long as it looks beige its all good
« Last Edit: May 23, 2003, 08:20PM by Gli »
Logged

Offline Pinsair

  • ka24e owner
  • post whore
  • *****
  • Posts: 1046
  • Karma: +14/-4
  • Gender: Male
Re:painting a spoiler
« Reply #8 on: May 23, 2003, 06:50PM »
i got my spoiler today will probably paint it tomorrow or something, how do u know where to drill holes in the boot? Should i just estimate?
Logged

Offline noss

  • Administrator
  • post whore
  • *****
  • Posts: 13882
  • Karma: +278/-50
  • Gender: Male
  • great scott!
    • antrx
Re:painting a spoiler
« Reply #9 on: May 24, 2003, 12:01PM »

measure twice drill once champ.. you dont want a bootlid that looks like a sieve.

meausre the width of the bootlid, get the centre point, measure how far apart the bolts on the spoiler are, take half of that measuerment, and measure that on the bootlid from the centre point. this way, the spoiler is centred.

make sure its straight too.. you dont want a funky new spoiler that is mounted crooked.
« Last Edit: May 24, 2003, 12:04PM by noss »
Logged

http://polyfedelicio.us/imgs/ - free image hosting for whatever you like

Offline Pinsair

  • ka24e owner
  • post whore
  • *****
  • Posts: 1046
  • Karma: +14/-4
  • Gender: Male
Re:painting a spoiler
« Reply #10 on: May 24, 2003, 03:37PM »
cheers for the help
Logged

Offline ZEXTCY

  • antrx.com junkie
  • *****
  • Posts: 825
  • Karma: +24/-3
  • Gender: Male
  • I dare ya
Re:painting a spoiler
« Reply #11 on: May 24, 2003, 11:46PM »
if you use a pencil (as it can be rubbed off) mark where you want the spoiler to sit
now put some extra long screws in the spoiler so it sits up high enough to mark the boot where the longer screws come down and that`s where you drill the holes
Logged
What is the point of a signature, who REALLY reads it??

Offline noss

  • Administrator
  • post whore
  • *****
  • Posts: 13882
  • Karma: +278/-50
  • Gender: Male
  • great scott!
    • antrx
Re:painting a spoiler
« Reply #12 on: May 25, 2003, 03:28AM »
but if you do that, u might mount it offcentre..  :P
Logged

http://polyfedelicio.us/imgs/ - free image hosting for whatever you like

Offline ZEXTCY

  • antrx.com junkie
  • *****
  • Posts: 825
  • Karma: +24/-3
  • Gender: Male
  • I dare ya
Re:painting a spoiler
« Reply #13 on: May 25, 2003, 08:54PM »
lol

trhat`s why you sit spoiler on boot first and find centre and mark with pencil  ::)

Logged
What is the point of a signature, who REALLY reads it??

Offline calteoh

  • antrx.com full member
  • ***
  • Posts: 202
  • Karma: +2/-2
  • Gender: Male
  • first car eagerness
Re: painting a spoiler
« Reply #14 on: Sep 16, 2004, 07:15PM »
ok today i went out and bought some 600 wet + dry and some 1200 wet +dry.

now
Quote from: aussie-gli on May 22, 2003, 12:08AM
Here's a few pointers....

* If the paint on the spoiler is in good nick, just rub it back with 800 and spray your colour over that.


now the condition of the spoiler is very good... no scratches at all a nice clean surface.
i'm wondering whats the technique or rubbing back paint.
how will i know if i'm doin it right?
and when will i know to stop rubbing back?
Logged

Offline SSS

  • Administrator
  • post whore
  • *****
  • Posts: 8279
  • Karma: +5020/-3
  • Gender: Male
Re: painting a spoiler
« Reply #15 on: Sep 16, 2004, 07:34PM »
If you've got sufficient coats of paint, rub it back until all the orange peel is gone. You can see by holding it up to a light source and looking along the surface of the spoiler.
Logged

Offline vector

  • antrx.com junkie
  • *****
  • Posts: 710
  • Karma: +16/-55
  • Gender: Male
Re: painting a spoiler
« Reply #16 on: Sep 16, 2004, 11:23PM »
Quote from: calteoh on Sep 16, 2004, 07:15PM
ok today i went out and bought some 600 wet + dry and some 1200 wet +dry.
now
now the condition of the spoiler is very good... no scratches at all a nice clean surface.
i'm wondering whats the technique or rubbing back paint.
how will i know if i'm doin it right?
and when will i know to stop rubbing back?

ok what youll need is a sanding block and some water wet the sand paper wet the spoiler and start rubbing also have a hose on it constanly whilst sanding itd be better to go 400 then 600 as itll take more time to do it with 600 but youll get there and 600 is best for enamal paints 800 is acryllic youlll know when its time to stop as the primer will be exposed and you shoouldnt be getting orange peel texture if you do the paints to thick
Logged
"Until the philosophy which hold one race superior and another inferior is finally discredited and abandoned...WAR! So that is prophecy, and everyone know that is truth. And it came out of the mouth of Rastafari"
Pages: [1]   Go Up
« previous next »