[ antrx.com ]

U12 Bluebird, Pintara & Stanza => the style department => Topic started by: Jtas on Feb 21, 2004, 06:33PM

Title: mesh in front bar
Post by: Jtas on Feb 21, 2004, 06:33PM

i've just meshed my grill properly, which looks pretty good. and now ive got a fair bit of mesh left over so i want to mesh the gaps below the number plate in the front bar...  to do this properly i reckon i'll have to take the front bar off, is this hard or is it a piece of cake?? are there many bolts holding it on??

i'll also do the holes where my foggies were but that should be pretty easy...

and ill get pics when i can when ive finished it and got my clear indicators...

thanks guys,
james

Title: Re: mesh in front bar
Post by: Resin on Feb 22, 2004, 09:32AM

well i have never done it ...but when we on the latest NSW cruise Beefy seemed to get off in seconds when he did a roadside fix it stop or wat i would call break it stop.  hehe ......any way it didn't look that hard ...

Title: Re: mesh in front bar
Post by: NZ_Pintara_TRX on Feb 22, 2004, 03:01PM

hey there

I have meshed the front bar under the number plate and it is not that hard all it is

1. in the wheel arch there is a screw at the top of the bumber and the may be one ant the bottom of the bumber as well

2. in the center of the bumber just under the frount grill there is 2 plastic grub screws

3. the bumber is all so held in by some cliping system and it just needs a good pull

at the moment my 1 is only held by 2 screws

and a word of warning it is bloody ugly without the bumber
 

Title: Re: mesh in front bar
Post by: Jtas on Feb 23, 2004, 04:25PM

thanks, seems pretty easy.. ill get around to it when i have a chance :)

Title: Re: mesh in front bar
Post by: aussie-gli on Feb 24, 2004, 07:25PM

This is why my front looked like a couple of years back....

Different now, and probably gonna change again...



[attachment deleted by admin]

Title: Re: mesh in front bar
Post by: BEEFY_1600 on Feb 24, 2004, 07:49PM

Aussie how did u remove the middle bar from the middle bit that bar looks sick

Title: Re: mesh in front bar
Post by: aussie-gli on Feb 24, 2004, 08:10PM

Cut it out and did some plastic welding & fibreglassing... and then a respray

Title: Re: mesh in front bar
Post by: Milford on Feb 25, 2004, 07:33AM

Put the nissan badge on the mesh where it should be, it looks cool :)