Author Topic: 97 BLUEBIRD Head Unit Install HELP  (Read 2120 times)

0 Members and 1 Guest are viewing this topic.

Offline rambo180

  • antrx.com pre-pewbie newbie
  • *
  • Posts: 2
  • Karma: +0/-0
97 BLUEBIRD Head Unit Install HELP
« on: Dec 28, 2008, 08:48PM »
Hi,

I'm trying to install a new head unit. Where do I start unscrewing?

So far, I've unscrewed 2 screws pointing upwards, just above the old unit.

 i've found 2 hexagonal shaped screwheads behind the rear ash tray (could be undone but not required?)

I've found 2 plastic caps with square holes in the middle, positioned towards the middle of the car, near the left knee (if in drivers seat), and same on other side.  Undo these??

Where do I start my attack?

Thankyou very much, I'm a newbie. Help appreciated!!

Offline slim

  • post whore
  • *****
  • Posts: 1517
  • Karma: +16/-7
  • Gender: Male
  • Nissan Bluebird SSS 1996
    • Pictures
Re: 97 BLUEBIRD Head Unit Install HELP
« Reply #1 on: Dec 28, 2008, 10:48PM »
rear ash tray dont need to come out
Your right with the two above the head unit.
Remove the gear boot and plate ( if its a manual, autos should a similiar set of screws) there are two screws under the plate
theres two screws where drivers left knee is below the wood trim.
From there the trim around the stereo should come off.
Then its just a few more screws holdin stereo in
  • Bosch HID Kit, Clear Side & Front Indicators + Bulbs
  • B&M Shortshifter
  • JVC DVD Touchscreen 5.1 Surround Sound
  • Full Whiteline Kit
  • Tokico Shocks
slim's 1996 SSS Bluebird Project Thread

Offline rambo180

  • antrx.com pre-pewbie newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: 97 BLUEBIRD Head Unit Install HELP
« Reply #2 on: Dec 29, 2008, 10:11PM »
Thanks, struggled with the electronics but all done.

Cheers again.