After an expression of interest on who would be interested in purchasing an NVSRAM board for the KA, this is an adaptor board that goes in place of the standard ecu chip and is connected to the Consult port.
Basically, this allows you to not only do datalogging via the consult port, but you can remap the ecu through the consult port, using DeviousKA's Nemesys program, which is written specifically around the U12 KA24 ECU.
Go here for the full thread:
http://eccs.hybridka.com/viewtopic.php?f=9&t=1770Software is open source, so if you like it, DeviousKA appreciates donations for his hardwork
I'm looking at getting a run of 10 boards made (I will be putting one in my daily driver TRX) at an approximate cost at this stage of $70 AUD + postage.
Those that are interested, you're looking at an initial deposit of 50% to kick off the order, turn around time at this point I would estimate at 4 weeks, but i'll keep this thread updated as the info comes to hand.