I recently did a self-install of a small sub and amp which went well until yesturdy
Instead of breaching the firewall i powered the setup through an empty slot in my fuse box under the steering column and
also gounded with a screw near there
It was all workin fine and dandy till my unsecured sub slid round a corner and the wires came loose,
i clamped the wires back in and sure enough it works again
BUT when i start the engine and drive off, it only takes a few 100m's before it stops workin, every time
When i just have the power on it works fine
I am that puzzled, and can only think that some damage was done when it came loose or possibly from the wiring
Any thoughts on this would be much appreciated
Cheers