Author Topic: Fitting Reco Head and setting TDC  (Read 1903 times)

0 Members and 1 Guest are viewing this topic.

Offline ca20e

  • antrx.com junior member
  • **
  • Posts: 21
  • Karma: +0/-0
  • Gender: Male
  • 87 Pintara - Sedan - Manual - CA20E - RWD
Fitting Reco Head and setting TDC
« on: Nov 23, 2008, 11:02PM »
About to remove the current cylinder head on my car and put a reco one on, i figure that if i set it all to TDC before i start pulling anything off then it should go back the right way too, mainly the dizzy anyway......as to the cam when putting the reco head on if the valves on number one cylinder are both rocking open and the indent (white dot) on the cam wheel is pointing directly up - then that will be set at TDC position ??   Is that correct ??