Author Topic: Oil filter relocation kit heads up...  (Read 1057 times)

0 Members and 1 Guest are viewing this topic.

Offline pedro666

  • post whore
  • *****
  • Posts: 2324
  • Karma: +26/-8
  • Gender: Male
  • VET NEO VVL is how I roll...
Oil filter relocation kit heads up...
« on: May 28, 2014, 09:19AM »
Here is a strange one for you guys thinking about, of have done an oil filter relocation. I changed my oil & filter over the weekend, only to discover when i cranked over the engine to have no oil pressure! I decided to fit a K&N filter I had had for some time, after refitting the old one back on, BAM!, Pressure again.. The only thing I could see, was the Cusco That I had on there in/out filtered section is pretty much flat, while the K&N ( as well as most Ryco etc) are recessed, with about a 10mm gap. this must cause cavitation or something and interrupt flow. I now have a HKS which is also fine, just a bit smaller. Just something to consider when doing this upgrade, I only had the Cusco initially as it is magnetic and i thought it wouldn't hurt to fit one after tapping the block for the turbo. ;)
the words "race car" spelled backward still spell "race car"? 




skype_shannan801

Offline nickybeach

  • antrx.com pre-pewbie newbie
  • *
  • Posts: 2
  • Karma: +0/-0
Re: Oil filter relocation kit heads up...
« Reply #1 on: Jul 9, 2015, 06:30PM »

I read it several times, I'm very impressed because I have a very good knowledge really.

Offline pedro666

  • post whore
  • *****
  • Posts: 2324
  • Karma: +26/-8
  • Gender: Male
  • VET NEO VVL is how I roll...
Re: Oil filter relocation kit heads up...
« Reply #2 on: Jul 12, 2015, 03:02AM »
super , thanks for asking...
the words "race car" spelled backward still spell "race car"? 




skype_shannan801