[ antrx.com ]

U12 Bluebird, Pintara & Stanza => maintenance issues => Topic started by: sticks1977 on May 30, 2012, 08:44AM

Title: Engine mounts replaced - still have vibration...
Post by: sticks1977 on May 30, 2012, 08:44AM
I picked my car up from the local mechanic yesterday as my trusty old faithful '91 Pintara needed three new engine mounts and a water pump.

Firstly they said the engine mounts were difficult to source from their supplier due to the car being 20+ years old. The vibration upon start-up and when braking or turning corners is gone so the new engine mounts seem to be doing their job.

The only thing I have noticed - which the mechanic also mentioned - was that there is still some vibration when accelerating and also when sitting idle at the traffic lights.

The mechanic mentioned to me that the vibration will initially be there to begin with while the engine mounts are "new" and the rubber is hard. Since I know two-thirds of not much mechanically about cars should I be expecting this vibration to cease or be not noticeable after a week or three?

Also what was mentioned was that one of the engine mounts had to be placed into the old engine mount bracket as the supplier had given the mechanic the wrong bracket.

Thanks for reading and look forward to any replies that can - possibly - put my mind at ease...

Regards, Shaun (sticks1977)
Title: Re: Engine mounts replaced - still have vibration...
Post by: Budgie on May 30, 2012, 12:37PM
Sounds fine, some vibration is normal.

My '97 U13 Bluebird has a noticable vibration at idle which you can feel slightly through the steering wheel. No big deal :)
Title: Re: Engine mounts replaced - still have vibration...
Post by: SSS on May 30, 2012, 02:42PM
How much did the mechanic sting you for the mounts?
Title: Re: Engine mounts replaced - still have vibration...
Post by: Pure_Sincerity on May 30, 2012, 02:51PM
Probably too much, gearbox mounts are like $180 alone.
Title: Re: Engine mounts replaced - still have vibration...
Post by: mpot on Sep 30, 2012, 04:46PM
Probably too much, gearbox mounts are like $180 alone.

Over the years, the price of replacement mounts from Nissan keeps going up ;-(

That's one of the reasons why I get replacement mounts cast in polyurethane (http://martybugs.net/Pintara/mount.cgi).  It's cheaper, the mounts last a lot longer, and it's a bit stiffer than the rubber mounts.
Title: Re: Engine mounts replaced - still have vibration...
Post by: SSS on Oct 19, 2012, 07:50AM
Which will either be made by Kelpro or Mackay. Supersteal do sell them, at a markup but definitely less than Nissan direct.

Another option is buy them from Rock Auto in the US, I could only find the front / rear and side engine mounts, couldn't find the gearbox mount for the manual trans. Fairly cheap, Between $16-40 USD plus delivery depending on which mount.

Either way martin, you can't lose with urethane filled mounts.